RH
BluePeg
1 RH Blue Peg is supplied with each Pro Package. The RH BluePeg is a sensor for relative humidity and ambient temperature with a protective cover over the
sensing pad for calibration stability.Readings can be obtained by connecting:
- RH Cable for probe readings in concrete
- RH Adaptor for ambient air conditions
- RH BluePort for all applications
|
RH |
Convenient and time-saving.
Since multiple test locations are necessary to obtain representative moisture data for each test site, leaving several RH BluePegs inside the sleeves cuts down on waiting time for the sensors to be acclimated.
Sleeves
with Caps
20 Pack
10 Sleeves with Caps are supplied with each Pro Package.
The Sleeve is the liner for the test hole, drilled with an 11/16 " concrete drill bit. The Cap deals the opening.
The RH-S20 pack contains 20 sleeves and 20 caps with seal ring.
RH Adaptor
The
RH Adaptor can be used for any application where the long
RH cable becomes cumbersome to manage. Ideal for measuring ambient
conditions of relative humidity and temperature.
3.5 mm male plug on both ends to connect meter to RH BluePeg.
RH Cable
1
RH-Cable
is supplied with each Pro Package.
Easy-to-use 3.5 mm Plugs to connect and disconnect cable from meter and
RH BluePeg Sensor.
Slide-Hammer Electrode E12 for Ligno-
VersaTec
-Pin Mode
1
Electrode E12 is supplied with ProPackage VP-4. Recommended for the
hardwood floor installer, because it is the only tool to check subfloors
without removing the floor planks.
Insulted pins allow obtaining true core readings. can be used in wood
and in soft building materials such as sheetrock or plaster.
